MS-DOS Bootcode from bootsector file bs_msdos.bin into USB-Driveīootsector Then Save modified USB-Drive Bootsector as Bootsector File NTBOOT.bs in folder btsec on your USB-stick.
Use mkbt.exe to Save the USB-stick Logical Drive bootsector as file Without Set Active you will get DISK BOOT FAILURE.Ĭopy XP BootFiles ntldr, NTDETECT.COM, Bootfont.bin from your XP C-drive to USB-stickĬopy XP BootFile boot.ini (with all New Boot Options) from usb_cfg Folder to your USB-stick
Use FAT Format and Set Active OR use PeToUSB toįormat such partition. Instead of an USB-stick one can also make a Bootable USB-Harddisk using theįor USB-Harddisk make 1900 MB partition at beginning of the USB-Harddisk
#Grub4dos boot install#
If you did prepare your USB-stick with usb_prep8.cmd so that it can be usedįor Install of Windows XP, than you had already a stick with boot.ini MenuĪnd the required bootfiles, and you don't need to do steps 1-4 If you canĬheck BIOS bootsequence settings or use different USB-stick / computerĬombination, OR Instead of PeToUSB use HP USB Disk Storage Format Tool Test if your PC is Booting from USB-stick with boot.ini Menu. Is used as first Boot device type and USB-Drive is seen as first or F2 and change Boot settings more permanent so that Harddisk Reboot your PC with USB-stick plugged in and Enter BIOS Setup by pressing MS-DOS is not available on 4 GB Apacer HT203, whereas 1 and 2 GB sticks are Apacer HT203 OR Buffalo FireStix RUF2-R2G-S Booting from USB-sticks of 1, 2 and 4 GB have been used Where USB-stick is mentioned in the description, USB-Harddisk with 2 GB FAT Adapt the configurationįiles and the content of the MULTI_CONTENT folder to your personal needs. To USB-Drive by the USB_MultiBoot5.cmd program. The content of MULTI_CONTENT folder is copied The USB_MultiBoot5.cmd programĬan be used for making MultiBoot USB-Drive for Install of Windows XP withĮxtra Boot Options for System Recovery with Ghost.Īll Editable Configuration Files for making a MultiBoot USB-stick are given TheĪttachment gives USB_MultiBoot5.zip file. MultiBoot USB-Drive, instead of the Manual Procedure as described below. The USB_MultiBoot5.cmd Batch Program can now be used for making such In this wayĪ powerfull Admin's Swiss Army Knife is obtained. WinPE 2.0 and SYSLINUX can be used directly from boot.ini Menu. Options as MS-DOS, FREEDOS 1.0, GRUB4DOS, BartPE, TXT-mode Setup Windows XP,
#Grub4dos boot how to#
In this Guide is described How to Make a MultiBoot USB-stick, where boot Guide for MultiBoot USB-stick with boot.ini Menu